Orbit II Stand-Alone DVD and CD Copier
Quick Reference Guide
Installation
Instructions
Basic Duplication
This is a reference for basic operation and duplication only. Please read the
manual for more detailed instructions on the advanced features of the Orbit II.
1. Prepare a workspace
for the Orbit II.
The
dimensions required for the
Orbit II are shown in Fig. A.
Blank Media Note: Authoring DVD media is not supported
1. Load discs into the Input Hopper. The
first 5-6 should lay flat, the rest should
lean against the short input hopper rod.
See Fig. C.
2. Remove the Power Cord, Output
Bin, 3 Input Rods, and Starter Kit
from the box. The Starter Kit
includes the Documentation CD,
Warranty Card, and Quick
Reference Guides. Position the
Orbit II in the prepared space.
2. Press “Yes” when the display reads
“Copy?”
3. Place the Master Disc in the tray when
the reader drive opens. See Fig. D
below.
Fig. A - Workspace Dimensions
3. Make sure the switch on the
back of the Orbit II is in the OFF position.
4. Press the “Yes” key again to start
4. Plug the power cord into the back of the Orbit II, then into the
nearest power outlet.
duplication.
Fig. C - Loading Procedure
5. When the input hopper is empty, either
add more discs and press “Yes” to
continue, or press “No” to end the
duplication.
NOTE: It is recommended that you do not use an outlet that
is already powering other equipment.
5. Install the Output Bin on the left
side. Extend the bin out to the
2 Narrow
Input Rods
Wide
Input Rod
6. Once the duplication has been
completed, the reader drive will eject.
Remove the master.
left until it snaps into position.
6. Install the Input Rods as shown
in Fig. B.
7. Remove the copies from the Accept bin
on the left. Rejected discs, if any, will
be to the right of the Orbit II.
7. Turn on the Orbit II.
Fig. D - Reader Drive Ejected
Please save all packing
materials from your Orbit II!
Please refer to the Operator’s Manual for information on the advanced
duplication features of the Orbit II.
Fig. B - Input Rod Positions
820-00151-01 Rev M
|